Unfortunately Lee, I doubt very much if my engines will ever be made by CNC.
I design and make on the run, manual machining here and there where necessary. I doubt if CNC could keep up with my one off production. I don't even use CAD, just rough sketches.

This was designed and made just like I described above.



Or maybe a three rotor air/steam turbine will wet your whistle



Both about 4.5" high

I need massive help for when the CNC eventually turns up, not hardware, that is all sorted hopefully, but where to start in getting it to do what I want.

I am looking at Dolphin and Mach III software.


Bogs