Hi to everyone

[Lee Roberts]

Hi bill, i'v got 3 motors that have seen very little use if you would like them?

Welcome to the site!

[wildbill]

Hi Lee, thanks for the response. i have started building the gantry and table, 100cm X 50cm table, i have also made some linear bearings, so i guess the motors need to be quite small, i intend using a small (850 watt) router or a dremmel. I'm reading some stepper theory and i will build the drive board (not for cost reasons but because i enjoy doing stuff !!). What size are your motors and what cost ? do you think they would be suitable give the sizes mentioned above ?

Wildbill.