Thread: sudden change of direction
Hybrid View
-
01-03-2010 #1
Hello, i've run into a bit of a problem with my machine
i have 2 steppers running the X axis and for some reason one of them keeps changing direction.
both drivers are conected to the same axis output on my system4 board??
also the direction LED dosn't come on???
could having unscreened wire be the culprit? any advise apreciated:question:
-
01-03-2010 #2
are the drivers opto-isolated from the system4 board? How are they connected?
-
01-03-2010 #3
i have two DRV25PS boards wired straightto a ext.module.
i've picked up some sheilded wire today anyway and i'm going to re wire the lot just in case
-
04-03-2010 #4
panic over, it was a loose wire
-
06-03-2010 #5
Loose wire and no damage done, you "lucky" "lucky" boy! lol
.Me
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Am I heading in the right direction?....
By Lloyd in forum Gantry/Router Machines & BuildingReplies: 24Last Post: 24-06-2014, 09:09 PM -
x-axis on Orac losing direction
By asto in forum Motor Drivers & ControllersReplies: 3Last Post: 29-03-2013, 01:22 AM -
Geckodrive - The G215 Step and Direction or VCO
By Lee Roberts in forum Motor Drivers & ControllersReplies: 0Last Post: 31-03-2012, 10:42 PM -
NEW MEMBER: New Member, saying Hello and hoping for direction
By GMNOCNC in forum New Member IntroductionsReplies: 0Last Post: 07-03-2011, 11:50 AM -
Reversing motor direction in Mach3
By bruce_miranda in forum Artsoft Mach (3 & 4)Replies: 2Last Post: 16-11-2008, 06:54 PM
Bookmarks