Threaded View
-
03-03-2010 #5
Hi Irving,
Thanks for the offer - there's some relatively hard to source electronics bits & bobs stuff I've been waiting to get from Cricklewood...so I might as well bite the bullet & get ordering from them & lob in a couple of 78l08s too - they've no minimum order, but £3 P&P (not bad & saves me having to drive over there!)
Thanks for the basic outline diagram too.
Re getting my finger too close to the 'big wiggly amps' - yep, lots of high voltages on this board, but not overly worried (originally trained in fixing valve based radar kit by the RAF many moons ago...I've had -500V DC across me a few times while stooping in a darkened ops room fixing radar consoles ...enough to be careful nowadays!)Last edited by HankMcSpank; 03-03-2010 at 10:48 AM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Mach lathe spindle speed control
By GeoffV in forum Artsoft Mach (3 & 4)Replies: 7Last Post: 21-05-2014, 08:34 AM -
FOR SALE: pdmx 107 spindle speed control board
By dazza in forum Items For SaleReplies: 0Last Post: 08-05-2014, 02:58 PM -
eBay: Denford Novamill SmartStep Control Board + Spindle Board
By danielbriggs in forum Items On eBay UKReplies: 0Last Post: 30-05-2013, 06:52 AM -
eBay: UIM2901-5A Mach3 breakout board with spindle speed control
By Fivetide in forum Items On eBay UKReplies: 0Last Post: 05-02-2013, 07:25 PM -
Mini ITX board for Mach 3
By lateAtNight in forum General DiscussionReplies: 2Last Post: 17-08-2010, 10:47 PM
Bookmarks