Threaded View
-
30-03-2010 #1
Hi guys, im not the best when it comes to wiring things up, as you can see from my build log i purchased some servo drives and motors, these drive can accept clock and direction, but i have not got the foggiest on how do wire them up to my computer so mach will control them.
Ive got a BOB from previous build of a drive system (unfinished) if that is helps.
Ive attached the pdf of the drives and how they can be configured, if someone could have a flick through i would be very grateful indeed, im at my whits end :(
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Driver wiring advice needed...
By Wal in forum General ElectronicsReplies: 17Last Post: 09-06-2014, 06:11 PM -
Stepper Driver / PSU / Breakout board Wiring ?
By manofgresley in forum General ElectronicsReplies: 2Last Post: 16-08-2012, 05:41 PM -
FOR SALE: LCD Module, VGA Driver, OSD Control Panel, Inverter unused, Boxed
By Jimmybristol in forum Items For SaleReplies: 3Last Post: 10-12-2011, 11:36 AM -
Time for a purpose built motion control computer.
By GeoffV in forum General ComputingReplies: 17Last Post: 08-11-2010, 01:11 AM -
Driver wiring help...
By mike in forum Motor Drivers & ControllersReplies: 12Last Post: 21-09-2010, 09:29 AM
Bookmarks