-
07-04-2010 #1
plan request connection card PCPPS
Hello all please is what you can help me make a connection of limit switch and emergency stop on the map PCPPS (at DIY CNC)
thank you very much
-
07-04-2010 #2
What control software are you using? E-stop normally uses the in5 pin and limit switches can be linked to the other inputs. depends on what control software you are using as to set up though most are similar.
Michael
-
07-04-2010 #3
Michael thank you for the reply
MACH3 software as I please a quick sketch
http://www.diycnc.co.uk/html/pcpps.html
ali hedi
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
PCPPS B.O.B. - OK for spindle control?
By birchy in forum Spindles & Drive MotorsReplies: 4Last Post: 09-09-2013, 12:50 AM -
PCPPS V3 Power Supply?
By birchy in forum General ElectronicsReplies: 4Last Post: 10-12-2012, 04:21 PM -
NEW MEMBER: Designer with a plan looking for advice
By bigstu67 in forum New Member IntroductionsReplies: 2Last Post: 10-10-2012, 06:04 PM -
PCI parallel card / BOB
By artmin in forum Computer HardwareReplies: 11Last Post: 30-01-2012, 04:38 PM -
So... what do you plan to do over the hols?
By irving2008 in forum General DiscussionReplies: 5Last Post: 23-12-2008, 09:03 PM
Bookmarks