Play in linear bearings

[leadinglights]

Additional to my last question. I see that there are some THK 25mm sets ol linear guides and truck units on ebay, each set consisting of two rails and four trucks. Everyting seems to be right about them, but my only real question is, can they be cut to length? I know that it would almost certainly be possible to actually cut them with an abrasive wheel, but can this be done without damaging them?

Mike.

[HiltonSteve]

Cutting them is not a problem, I use a 1mm wide cutting disc in my angle grinder, goes through them like butter.

[John S]

Who's angle grinder ?????????

.