Quote Originally Posted by 1113562 View Post
Hi Bill,
I have managed to program 4 off 12F675 PICS but for a quick demo breadboard can I just install 1 or 2 Vernier PICs into the RS232 interface driver rather than all 4. If so do I need to install X then Y then Z etc in that order. I'm getting to understand your assembly code but i've not quite figured out the TxSyn operation yet on GP4 in relation to channel time slots.

Cheers, John

I have build a prototype board to test a single channel although the board is built to a level to take 3 of the PICs with expansion for the 4th.

On test with one PIC installed and connected up to a caliper I am getting something and it recognises the correct channel but the displayed valued is very eratic and not representative of the vernier positional movements. I'll need to get the scope out to see why it is so all over the place. Perhaps I have a noise issue with my set-up. The power supplies look quite stable with a DMM but without scoping it there could be some nasty spikes around... I'm getting there slowly.lol

I tried to add a few pics but I'm not sure if it worked