Threaded View
-
14-05-2010 #9
Glad to hear that the fan idea worked but not so glad to hear about your problems re-appearing.
I would try and get my hands on an old pc to run it off rather than a laptop, heard about one or two people that have had problems using them and then other people having no issues at all, just pot luck into which category you fall.
If you lived a bit closer you could and come and 'borrowed' one of mine as I have a stack of half decent PC's in the corner of the workshop that would do a better job of running mach3 than your laptop.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
x-axis on Orac losing direction
By asto in forum Motor Drivers & ControllersReplies: 3Last Post: 29-03-2013, 01:22 AM -
Help! Steppers losing steps and making a racket under slow feed..
By fasteddy in forum Stepper & Servo MotorsReplies: 23Last Post: 06-08-2011, 03:03 PM -
Missing Steps + Stalling X-axis
By danielbriggs in forum Linear & Rotary MotionReplies: 5Last Post: 02-09-2010, 02:59 PM -
z axis loosing steps
By ptjw7uk in forum Machine DiscussionReplies: 23Last Post: 10-05-2010, 07:38 PM -
dual drive x-axis?
By fasteddy in forum Linear & Rotary MotionReplies: 36Last Post: 13-06-2009, 11:05 PM
Bookmarks