help please with first attempt

[John S]

Get a multimeter and find which two wires make up a coil.
You have 4 coils so you will have 4 pairs of wires.

I'm guessing Black and white with black stripe is one ?
Red and white with red stripe second ?
Blue and white with blue strip third ?
Green and white with green stripe last ?

If so join white with black and white with red together , then feed red and black into 1A and 1B

Join White with blue and white with green then feed Bluee and Gren into 2A and 2B

[phill05]

Thanks John, have done as you said, tried again still no motor turn, in Diagnostic's show's all ref xyz in Red and X counter running up and now Red flashing on Output 1.

[phill05]

In Diagnostic's show's all ref xyz in Red and X counter running up and now Red flashing on Output 1.

now tried different driver card in Y same no motor output, Y pos running up, this time no Red flashing on Output, Current state of port pins 5 Green led's, Input signals current state all blank, Output signals current state all blank.