. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 19-06-2010 #18
    j2sip's Avatar
    Lives in North Philippines, Philippines.
    j2sip
    Last Activity: 25-05-2015 Has been a member for 9-10 years. Has a total post count of 20.


    Here's the pulley placement redesign as suggested by irving2008. The belt barely cleared the bottom V bearings. It now looked simplier despite the addition of another set of bearing pulley. Thanks a lot for your help.

    jordan
    Last edited by j2sip; 19-06-2010 at 06:22 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Timing Pulley/Belt sizing software
    By m_c in forum Computer Software
    Replies: 4
    Last Post: 12-04-2014, 03:33 PM
  2. 1:1 ratio - pulley sizes
    By dsc in forum Belt Drive, Pulleys & Timing
    Replies: 3
    Last Post: 12-04-2014, 01:30 PM
  3. pulley center distance vs. belt tension
    By dsc in forum Belt Drive, Pulleys & Timing
    Replies: 5
    Last Post: 13-01-2014, 10:48 PM
  4. Where can i find belt and pulley for a spindle?
    By JW1977 in forum Marketplace Discussion
    Replies: 5
    Last Post: 12-11-2013, 08:03 PM
  5. AC Motor upgrade - pulley sizes
    By birchy in forum Linear & Rotary Motion
    Replies: 7
    Last Post: 21-06-2013, 10:49 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules