Quote Originally Posted by action-kat View Post
Hi all just getting to the state of my build were I'm looking into the electronics,
I am looking at the Gecko G540 for the ease as I'm not clued up on electronics,
been looking at http://www.cncrouterparts.com/produc...products_id=75
for a complete option, a little more expensive than any thing in the UK but made newbie friendly.
Befor I shell out any money is there any other options that match upto the G540 I should be looking at.
Thanks for any input
KAT
will this set up run my 180Ncm - 1/4" Shaft - Hybrid Stepper Motors from http://www.arceurotrade.co.uk/Catalo...Stepper-Motors
or wold I be better of going for there steppers they are on a small gantree widgetmaster desktop mill.

thanks

Peter