Re-build

[routercnc]

Hi Phill,

I'm assuming Dremel type cutter for PCB or very light wood use, based on the clues in your post. I'd say you'll be OK for that with this setup, but a few comments:

Looks like your limit switch inputs are right next to the mains & capacitor. May get false trips outs, see how it goes.

Is the Z axis photo the new one or the old one? Only see 2 screws in each bearing, worth adding 2 more? Only a single pair of bearings, so limited X axis loading. Did the Z axis need to be that wide - supported rail and bearing combo could cope with much narrower and give more travel.

Otherwise, looks good. Keep up the photos . . .