The illusive Boxford 260vmc

[John S]

Don't bother,
Use a M04 P 2.0 command in your speed change code inside Mach after the M05 or M01 commands.
this will stop the motor, wait two seconds then carry on with the code.

It can be hard coded into the post processor so it's there but out of mind.

Also pays to use the same command after the M03 start up to give the motor chance to spool up before any cutting takes place.

[Ricardoco]

Don't bother,
Use a M04 P 2.0 command in your speed change code inside Mach after the M05 or M01 commands.
this will stop the motor, wait two seconds then carry on with the code.

It can be hard coded into the post processor so it's there but out of mind.

Also pays to use the same command after the M03 start up to give the motor chance to spool up before any cutting takes place.

Ahh yes but that wont help when im not using Mach
but thanks for the post processor hint, done and forgotten is what i like :)