Thread: The illusive Boxford 260vmc
-
17-08-2010 #221
on the x axis there is a gap at either end, but i'm not sure on the other axis.
-
17-08-2010 #222Always bear in mind that your own resolution to succeed is more important than any other - Abe Lincoln
-
17-08-2010 #223
-
17-08-2010 #224
on a bit of a side note, i picked up a soft ended r8 arbour today to test out the auto changer.
-
17-08-2010 #225
As soon as i get round to converting my 3hp boxford 240 tcl, i'll get onto turning it.
-
17-08-2010 #226
I did consider this but i was looking at the boxford covered up in the garden pooring with rain and decided i wanted to do something and i just decided i had a 5 relay board and small 12v powersupply so i did it, it may be overkill but at least with the relay design i can utilise the sensors output without a PC fullfilling my manual control Obsession!!! lol
Always bear in mind that your own resolution to succeed is more important than any other - Abe Lincoln
-
17-08-2010 #227
-
17-08-2010 #228
-
17-08-2010 #229
have you pulled that out of another holder that's in your spindle, as it looks just like the colchester easy change holder from a 30 int holder. Or does that go straight into the spindle.
Last edited by i2i; 17-08-2010 at 05:01 PM.
-
17-08-2010 #230
there should be a cap head screw that goes through the centre of your easychange holder. Or does the spindle bolt screw into the top of the easy change
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
The Boxford 260VMC as you probably never seen it before!
By rnr107 in forum Boxford Vertical MillsReplies: 36Last Post: 28-04-2021, 07:57 AM -
Boxford 260 VMC
By shoeswith in forum Boxford Vertical MillsReplies: 3Last Post: 10-04-2017, 06:20 PM -
boxford vmc 300
By bigred5765 in forum Boxford Vertical MillsReplies: 0Last Post: 22-04-2014, 04:22 PM -
Boxford mt2
By Hellfire in forum Boxford LathesReplies: 6Last Post: 03-08-2012, 08:46 AM -
Boxford 160 TCL
By Brinner in forum Boxford LathesReplies: 1Last Post: 31-03-2012, 09:11 PM
Bookmarks