Thread: Z axis motor 'lifting'..
-
03-08-2010 #11
Hi Ze0paz.
After the first debacle and your compelling point, am going to go right through all the wiring and give it a check and a tidy up..
On a really cheap note (done this whole thing on the cheap), has anyone tried using pipe lagging (the foam tube type with a slit down the length,) as a cable tidy? Dead cheap, very light and flexible.. Gonna get a bit and try and try to set fire to it today, unless someone knows a compelling reason not to (excluding pyrophobics)...
Steve..
-
03-08-2010 #12
Steve
Get down the pound shop or ikea and grab the stuff used for tidying up the tele cable clutter??????????? its a poundIf the nagging gets really bad......Get a bigger shed:naughty:
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Help with 3 axis CNC motor and drives
By domagoj55 in forum General ElectronicsReplies: 7Last Post: 04-03-2013, 12:51 PM -
THC lifting off sheet?
By lockyg in forum Machine DiscussionReplies: 2Last Post: 06-12-2012, 04:56 PM -
NEW MEMBER: Okuma Z axis motor
By hidro in forum New Member IntroductionsReplies: 0Last Post: 21-03-2011, 02:15 PM -
NEW MEMBER: Okuma Z axis motor
By hidro in forum New Member IntroductionsReplies: 0Last Post: 21-03-2011, 08:52 AM -
High Torque Motor Z Axis
By Lee Roberts in forum Stepper & Servo MotorsReplies: 5Last Post: 17-05-2009, 10:08 PM
Bookmarks