Fingers crossed it'll cut ally

[irving2008]

Well 1700W input is 850W+ output, ~1HP theoretically you have the power to take around a 5mm deep cut with a 8mm 2 flute cutter at a feed rate of 500mm/min... but in reality your rigidity probably won't be up to that... but I reckon 0.5mm cuts would be possible, maybe a little more with a brand new very sharp cutter...


thanks for the compliments

[blackburn mark]

nice one irving ! it sounds possible then

most of the work done on it will be in acetal delrin type plastics but i do need the odd ally bits and bobs

them motors nice and quiet!!