Fingers crossed it'll cut ally

[Jonathan]

Jonathan - Just noticed that your after a 100A 48v motor controller, I have got a few kicking around if you want one.
The ones I have take any voltage from 24 up to 48 and also can cope with anything up to 200A, fully programmable through 3 buttons on the front.
Let me know if you want some more information.

I'm definitely interested - those ratings should make it pretty indestructable! Do you have a datasheet or something for them? Is it sensored or sensorless?

Oh, and I am sure the price will be right!

Hehe, I hope so - just spent £274 on linear bearings and ballscrew so I've not got much money left!

P.S. I vaguely recall you posting about these before..?

PoKeys

That does look good, but very expensive compared to PCI parallel port card on eBay for £3.52.

[M250cnc]

That does look good, but very expensive compared to PCI parallel port card on eBay for £3.52.

Jonathan while it is correct that you can buy cheap PCI Parallel Port cards on Ebay they don't all work with Mach3 some don't have the option of using pins (2-9) for input or output. The PoKeys has dedicated drivers for Mach3 it even has a sub forum on the Mach3 support site.

A bit like comparing a Tata Nano against a Ferrari they both have four wheels, one is a lot more expensive which one would you prefer. ?

Phil

[Wobblybootie]

Just a quick question ... Any idea if it works with EMC2??

[M250cnc]

Just a quick question ... Any idea if it works with EMC2??

If you are talking about the PoKeys in theory yes as it is classed as a standard USB device.

But it would need someone to build the the driver whatever and i am not that person, the EMC2 has other options that mean the best guys do not want to bother and Boris the seller of the Pokeys doesn't have the desire either sadly as i have already asked him.

Phil

[Wobblybootie]

Cheers Phil, I know a EMC guru ... next time I catch him back in the UK I will ask him ... could be an interesting exercise ...

[M250cnc]

Cheers Phil, I know a EMC guru ... next time I catch him back in the UK I will ask him ... could be an interesting exercise ...

I have had a good look at EMC2, being a guru is a minimum requirement. LOL

I am on the mailing list, i think they talk Klingon, goes way over my head.

Phil

[Wobblybootie]

Same here ... that's why having a guru around is useful, that is if only he would stay in one country for long enough to have a conversation!!

[blackburn mark]

Tata Nano against a Ferrari

think ill go for the nano, i can afford it

iv weighed up all your posts and its all getting a bit rocket science so im going for the simple and cheap option
iv orders a pci ribbon extender and a pci parallel port, i should be able to sneak under my graphics card with that

all that for one more input

[M250cnc]

Mark list all your inputs and how you are using currently using them.

Phil

[blackburn mark]

off the top of my head..... mach setup is saying iv 4 inputs i can use... that would have been fine if i didnt have the slaved x axis
i need one for E-stop two for Z home one for Y home and one for Z home

i know there are other exotic ways of running switches parrallel/series etc but i woul like my "home" away from the extream edeges of my machine so i can easily keep an eye on lost steps

im assuming another port will give me another 9 inputs ???? cant remember,,,, my brain is melting :)