Fingers crossed it'll cut ally

[Swarfing]

Doh just realised i was replying to the previous page on this thread. Oh well

[blackburn mark]

http://cgi.ebay.co.uk/PCI-IEEE-1284-...item43a1c7cfa1

to late now, its orderd
ill find out soon enough :)

i might wire up without a Z home for now and add it when i can

[f750]

Hi Mark just read ball the thread,very interesting I use a 650kv outrunnnermotor on a mill with a 80 amp speed controller, servo tester and a 15volt psu supplly. I have run it on mach3 to cut some small bearing pockets taking a 1mm cut with a 6mm cutter Ihave not had any problems with heat build up. I have fitted a fan on top of the speed controller bolted to the main frame of the mill.

Tony