Thank you so much for your info but i think im either doing something wrong here or im dunce

So here is a break down what ive got set

Ports and Pins

Spindle: Enabled, Step Pin 7, Dir Pin 8, Step Port 1, Dir Port 2

Output Signals

Output #1, Port 1, Pin 8 (Dir)

Spindle Setup

Relay Control, CW output #1, CCW Output #1
Motor Control, Use Spindle Motor Output (enabled), Use Step/Dir (enabled)

I have tested the NO/C/NC connections buzzing out when its switched but nothing happens.

Also VDC testing on the 0-10v output on the Spindlev3 isnt changing at all, stays at 0.02vdc

Stu