Comments sought on new build: A CNC Router for RC Gliders and Planes

**gavztheouch** · 12-03-2014

I fancy giving this epoxy leveling technique a try. Can anyone recommend a good source and type of epoxy for the job.

**njhussey** · 12-03-2014

Originally Posted by gavztheouch

I fancy giving this epoxy leveling technique a try. Can anyone recommend a good source and type of epoxy for the job.

There are various ones:

West system 105 with the 209 slow hardner
Easy Composites
Reactive Resins Syntac EPAFD Slow Cure Epoxy Resin Pack
Infusion resin's

To name but 4. Most on here use Wests, Eddycurrent and I (although I've not mixed it correctly) have used Reactive resin and Jazz uses Infusions resins....take your pick!

**Clive S** · 12-03-2014

Neil Sorry about the cock up, it happens, its called a learning curve. I was going to comment on the mixing in your picture but now you are doing it again I will. You appear to have mixed it with a round rod I don't think that is good I think you need to do it with a flat piece of thin plywood or plastic as it will mix better. It says that on the WestSystem info about the correct way to mix and not to have the temp to high 20C is about right. Hope you don't mind me pointing this out. ..Clive