Comments sought on new build: A CNC Router for RC Gliders and Planes

[EddyCurrent]

I did a test pour today and it's looking good. The draught excluder worked fine but where two pieces butt up at corners it needs a bit of glue between as there was a slight leakage through the joint. I'll do a full report in my own thread after it has cured. Also I'm thinking that when the moat is removed the edges of the epoxy would look a lot better if a bead of liquid nails was run down, like you would with sealant, then run your finger along it to create a nice fillet that will set hard and can be painted over.
It looks like the epoxy did not penetrate into the foam, which was my biggest worry, and I think that's because the foam is waterproof.