Comments sought on new build: A CNC Router for RC Gliders and Planes

[njhussey]

Had a little play at lunch with the pillar drill and a bit of 60x60x5 RSA as I was thinking of making the dummy gantry base out of steel (plenty in the scrap bins at work cou"stock"gh) to cut up and mess with. I printed the hole pattern out on some paper and taped this to the bottom of the angle and centre punched the hole positions (high tech stuff this) prior to drilling them. Used a 6mm drill bit for a bit of clearance as the holes on the carriages are Tapped M5. Bolted the carriages to the angle and I reckon it should work OK and will save me spoiling a good bit of 10mm 6082 Ali plate.

I will get some draught excluder and try Eddie's moat method on the underside of the angle so as to get a level surface to mount the carriages on. I know for the sake of getting the rails parallel I don't need to do this but it means I can try the epoxy out to see how good it is and also try Eddie's foam moat idea at the same time