Comments sought on new build: A CNC Router for RC Gliders and Planes

[njhussey]

Neil,
I trust you read silyavski's thread about his epoxy method ?

With the metal strips?

[EddyCurrent]

With the metal strips?

Well maybe not, this is the thread, also read a few pages earlier; http://www.mycncuk.com/threads/6619-...3914#post63914

[njhussey]

Well maybe not, this is the thread, also read a few pages earlier; http://www.mycncuk.com/threads/6619-...3914#post63914

Yeah I've read it....my pour went OK apart from a couple of leaks which I cured and me not having the correct ratio. I got no shrinkage and the epoxy was level all round (measured with a straight edge and level) so I'm going to go as I did before. Mine is only 1300mm long so no where near the length of Boyan's which I think is where alot of his problems came from.