Comments sought on new build: A CNC Router for RC Gliders and Planes

[njhussey]

Hi Barry,

I'm drawing up a few more planes at the moment, a 3 CH old timer and a low wing Acrobat. The top one in the picture is based on the ugly stick and I'll eventually have that on eBay but want to build and fly it first!

The bottom of the pocket is rough, not ridged but rough as if its been either tearing or rubbing it...I think it's just a case of getting the speed and feed correct. That's the first bit of ali cut on the machine so long way to go yet!

[Clive S]

Do you remember the planes with the mighty midget motor and the unitone tx with the xfg1 triode(I think) valve in the rx with 4 wires

[njhussey]

Do you remember the planes with the mighty midget motor and the unitone tx with the xfg1 triode(I think) valve in the rx with 4 wires

Showing the your age there Clive aren't you.....bit before my time....Acoms Techniplus 2ch 27mhz was my first radio...with a Tamia Foed F150 Ranger car....

[Lee Roberts]

Do you remember the planes with the mighty midget motor and the unitone tx with the xfg1 triode(I think) valve in the rx with 4 wires

Can you say that again in English? A with what, for a with when ?

.Me

[Clive S]

Can you say that again in English? A with what, for a with when ?

.Me

See this http://myweb.tiscali.co.uk/norcimrad...ol/Radio17.htm and here is a bit more reading:- http://www.vintagercfiles.com/Grid_L...%20No%2010.pdf I am away at this time back Monday.

[GEOFFREY]

Mighty midget - forget all this low power electric nonsense - I remember all the fun I had with my ED BEE in a control line model (must have been around 1954/5. G.

[Clive S]

Mighty midget - forget all this low power electric nonsense - I remember all the fun I had with my ED BEE in a control line model (must have been around 1954/5. G.

Are you still going round in circles?