Hybrid View
-
29-07-2016 #1
Used the Router for the first time since going vertical and it's soooooooooo much easier ....no bending over the sides (kneeling for me as I had it on the floor!) to load the work. Just need to make a dust shoe ASAP and cyclone to stop the chips from flying everywhere....it fair flings the plastic chips (and the static little buggers cling to everywhere!!!) around
-
And the all important vid is!!!
..Clive
The more you know, The better you know, How little you know
-
29-07-2016 #3
Just watch your head.!! . . . . Got nasty habbit of twating you if not careful.!! . .
-
29-07-2016 #4
-
29-07-2016 #5
Looking great Neil. At one point it looked lie you'd created a plastic fountain :-). Hope your head gets better soon.
-
-
29-07-2016 #7
No because as soon as the oshiiiiiiiiiiiit button is pressed the gantry drops....... However........I do have my foam kneeling pad which I don't use anymore now it's vertical....I could put a couple of cable ties through the handles to loop under my ears to keep it strapped over my head!!!!
-
31-07-2016 #8
Nice vid Neil - lovely chip stream towards the end there.
BTW - would demi-jon bungs do for rubber stops or not man enough for the job - just a thought as the type for the airlock come pre-drilled iirc.My CNC Projects: https://www.youtube.com/imadethisoncnc
-
29-07-2016 #9
Last edited by njhussey; 29-07-2016 at 03:41 PM.
-
The Following 2 Users Say Thank You to njhussey For This Useful Post:
Thread Information
Users Browsing this Thread
There are currently 13 users browsing this thread. (0 members and 13 guests)
Similar Threads
-
Does anyone want to build me a cnc router?
By totally useless in forum Open Source Designs & PlansReplies: 25Last Post: 05-05-2014, 12:44 AM -
My new, and first build....comments greatfully received
By berk in forum Gantry/Router Machines & BuildingReplies: 7Last Post: 12-01-2014, 03:15 PM -
BUILD LOG: CNC Router New Build
By PilotTom in forum DIY Router Build LogsReplies: 12Last Post: 25-05-2013, 03:49 PM -
BUILD LOG: A3 Router Build
By GTJim in forum DIY Router Build LogsReplies: 6Last Post: 17-02-2012, 12:53 PM -
CNC construction TUNISIA give your comments
By ali hedi in forum Gantry/Router Machines & BuildingReplies: 5Last Post: 06-07-2011, 11:58 PM
Bookmarks