Comments sought on new build: A CNC Router for RC Gliders and Planes

[njhussey]

Home Neg in Homing Limits screen.....

Sent from my HUAWEI VNS-L31 using Tapatalk

[Clive S]

Home Neg in Homing Limits screen.....

Sent from my HUAWEI VNS-L31 using Tapatalk

Neil I take it that when the z moves down it is going -ve the homing switch at the top so it will home upwards +ve

[njhussey]

Neil I take it that when the z moves down it is going -ve the homing switch at the top so it will home upwards +ve

You're correct Clive, knew there had to be a setting but wasn't sure till I read the manual.

Set my park position too for changing bits and also for parking the gantry at the end of the day....slowly getting there with it.

Limits next, then enclosure, counter weight, proper dust shoe, LED lights...the list goes on!!

Sent from my HUAWEI VNS-L31 using Tapatalk

[JAZZCNC]

Neil are you sorted.?

Either Home neg are use the Reverse option but will depend on how axis is setup. one of them combo will sort you.

[njhussey]

Neil are you sorted.?

Either Home neg are use the Reverse option but will depend on how axis is setup. one of them combo will sort you.

Sorted cheers Dean, I reversed the axis but then on doing the simple tool height routine in Ger's screen set it sent the Z into the hard stop...a bit of reading the manual and "Home Neg" sorted it.