Mach3 limit setting and G-code creation

[audioandy]

Are you using a fully licenced version of Mach?

If not you are limited to, I think 500 lines of code.

You can set up soft limits in Mach were you tell Mach the max travel for each axis, which will stop over travel without the need for limit switches.


andy

[HUKBMBEAR]

Thanks GeorgeD - No there are no limit switches on my CNC.

Thanks Audioandy the version of Mach3 is not a fully licenced version, however the run doesnt event get as far as 100 lines of code. Thanks for confirming the availability of software limits - I shall have to do a bit of digging to see where in the software they are set.

Thanks

Ken