hello from down south

[geza]

I got a ballscrew kit from the states, because i wanted to get it converted quick.
Then left is few months to save up for the motors and drivers.
Will see if i can take some pics tomorrow.

[pjm]

Howdy Geza,

I'm in Corfe Mullen, so probably 5 mins from you! My machine write up is at http://wiki.linuxcnc.org/emcinfo.pl?Pjm

regards,

Paul.
http://twitter.com/UHF_Satcom

[geza]

Impresive stuf paul.
This is a few pics i took of the mill, i still need to add the X and the Y axis motors and three drivers.
The Mill has been sat in my workshop for a few months so looks like it has a bit of rust in places, but is nealy new with only a few hours of use.
I will get started on the motors and drivers next week.
Anyone have an idea what size motors to go for on the X and Y axis?
The motor mounts are nama 23 i think