Thread: Wire Connection Diagrams
Hybrid View
-
30-04-2009 #1
I worked for MCP for 13 year, and left about 2 months ago.
They are just down the road from me.
I do buy our stepper drivers from MCP, and MCP buy our mechanical products like ball screws, linear bearings and rails.
As for what stepper motor, well i would look at the SY85STH65 or the SY85STH118, these will work very well with the MSD980.
The current motor is only about 1.8Nm holding torque so any of these motors will be higher power.
Visit Us: www.automationshop.co.uk
-
30-04-2009 #2
hi gary....?been to your site(zap)is thesy85th118-4208 motors I see a price of +£28 pounds is that correct?....bobin
Last edited by bobin; 30-04-2009 at 07:30 PM. Reason: crap spelling
-
30-04-2009 #3Visit Us: www.automationshop.co.uk
-
30-04-2009 #4
sorry for hogging your time but on the msd980 boards on direction you have a plus 5v and a minus?? what signals are needed for these....will the +5 and low single wire goto +5 ,,if so what goes to the neg-.....bobin
-
30-04-2009 #5Visit Us: www.automationshop.co.uk
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Which Connection ?
By manofgresley in forum Stepper & Servo MotorsReplies: 17Last Post: 13-07-2020, 01:55 PM -
Connection the plasma cutter to the CNC machine?
By gr8fun in forum Plasma Table MachinesReplies: 1Last Post: 22-05-2014, 10:49 AM -
Or Guidance ;) Connection Name(s)
By Carlb1058 in forum Marketplace DiscussionReplies: 6Last Post: 13-07-2013, 12:48 AM -
ghost in the x axis - bad electrical connection
By jonm in forum General ElectronicsReplies: 5Last Post: 11-04-2010, 08:31 PM -
plan request connection card PCPPS
By ali hedi in forum General ElectronicsReplies: 2Last Post: 07-04-2010, 08:18 PM
Bookmarks