Thread: Total novice and lost
Threaded View
-
08-09-2010 #32
Last Activity: 18-08-2013
Morning,
I've tested both cables for continuity and they are fine, beeping 1 on 1, 2 on 2 etc.
I also tried puting the values for STEP and DIRECTION on the X not the Y and the Y still moved, I assume that means the figures are starting the Y motor no matter if X, Y or Z has the value.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: From Oz - ex of Cardiff anf lost :P
By Carlb1058 in forum New Member IntroductionsReplies: 6Last Post: 02-04-2013, 04:57 AM -
NEW MEMBER: Hello - total newbie!
By eggsBenedict in forum New Member IntroductionsReplies: 15Last Post: 05-01-2013, 12:47 AM -
NEW MEMBER: Total noob about to embark on a build.
By Wal in forum New Member IntroductionsReplies: 6Last Post: 21-12-2012, 02:48 AM -
NEW MEMBER: Hello everyone. Total newbie here. Where do I begin?
By DarkWalkJRB in forum New Member IntroductionsReplies: 2Last Post: 07-02-2012, 08:31 PM -
Total novice seeks advice on stepper motor drivers
By R.Andersen in forum Motor Drivers & ControllersReplies: 1Last Post: 25-01-2012, 11:34 AM
Bookmarks