Quote Originally Posted by M250cnc View Post
Jonathan any type of wood table is going to fail to sufficiently clamp metal to it...
A steel plate with 50x15 bars with 70x15 bars mounted on top to form the tee slots your require, and steel would be my preferred material.

Steel wont warp when wet/different humidity you would have to set your X & Y Axis to run parallel to the plate, now you might think this is a disadvantage not being able to machine the bed to suit the X & Y
Surely it all depends on what size cutter / feedrate I'm using - if the cutting forces are not to high etc. I was thinking more using the T slots for clamping wood, and using them to clamp my large milling vice (6" jaw, opens up to about the same) to the table for when I want to machine metals. That's still limiting me to only relatively small bits of metal though. If I want to machine a big sheet of aluminium then it's not going to be more than 8mm thick (cost again), so a 6mm cutter would suffice. What's the cutting force on a 6mm end-mill on aluminium at a decent feedrate? Surely not so much that lots of clamps on MDF won't hold it?

I agree putting steel strips on the bed is a good plan, but again very expensive - unless you know of a better supplier than me! I could skim the existing 18mm MDF bed with the router before putting the steel on top. That should get it reasonably parallel. I guess I could afford to make a smallish steel bed.

(Sorry I probably could have made this post a bit less rambling, I'm just thinking aloud.)