Click image for larger version.  Name: gmill.JPG  Views: 816  Size: 1.09 MB  ID: 24312Click image for larger version.  Name: bcut.JPG  Views: 794  Size: 630.7 KB  ID: 24313Click image for larger version.  Name: pcb.JPG  Views: 808  Size: 883.2 KB  ID: 24314 Hi hope this has uploaded my pics.

I have made lots of bits for the big mill jncluding a 4 jaw chuck fitting. faceplate , fly cutter. The overarm is not yet perfected. I wanted to do in line boring. The spindle has a taper which fits into the chuck and faceplate with a central bolt and tapped hole down the middle. These bits are made from old trailer hubs whose central hole has been filled with molten aly and then machined to a taper. I made a tool post for lathe tool out of cast iron block.

Not done much on the mill recently since I got the router table, not very big but OK for pcb,s. These tables are good value for money but the table needs to be milled flat with its owm cuttrer. An extra set of collets was bought and the toolstation hinge cutter did the trick. The material on the table top is laminate flooring left over from my bathroom.

Buy for now Keith