Thread: Driving floating end (ballscrew)
Threaded View
-
09-09-2010 #5
jesus irving!! dose your mind ever sleep?
i was starting to sweat over the figures... id have still been at it till the sun came up
0.2mm... thats a bit depressing... i was hoping the aluminium frame would off set some of it but at almost twice the exspansion of steel (with a bit of carbon in it) im still looking at about 0.2mm i think
back to the drawing board
cheers for doing the maths irving xxxxxx
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Plasma floating head...
By Davek0974 in forum Plasma Table MachinesReplies: 27Last Post: 01-01-2015, 01:52 PM -
Driving me insane
By Bush Flyer in forum Motor Drivers & ControllersReplies: 17Last Post: 14-04-2014, 03:55 PM -
ballnut housing and floating end ballscrew assembly
By dsc in forum Lead Screws, Nuts & SupportsReplies: 12Last Post: 12-07-2013, 08:22 AM -
non-locating / floating bearing - shaft location
By dsc in forum Linear & Rotary MotionReplies: 5Last Post: 28-06-2013, 10:07 PM -
Driving 2 steppers from one driver?
By Dan Brown in forum Stepper & Servo MotorsReplies: 2Last Post: 20-12-2009, 07:26 PM
Bookmarks