. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 18-09-2010 #1
    mike's Avatar
    Lives in west midlands, United Kingdom.
    mike
    Last Activity: 09-01-2012 Has been a member for 9-10 years. Has a total post count of 10.
    Hi
    i have upgraded my drivers to Zapps 752 5.2A drivers in the control box (Gary has been amazing & the service is FAST) as with anything i do i do every thing over the top instead of gradually do things bit by bit i find myself getting ahead of myself but i am currently stuck with the new drivers as i dint under stand where the -5v signals i know from the diagram on page 7 http://www.slidesandballscrews.com/p...uals/PM752.pdf

    the pulse+ & dir + take the 5v+ but i don't know where the 5v- goes to, i am currently using a routout cnc break out board http://www.routoutcnc.com/25WayD.pdf from my old system i was told it goes to this but this doesn't
    make sense i was hoping there was someone on this forum could point me in the right direction
    thanks guys
    Last edited by irving2008; 19-09-2010 at 12:53 AM. Reason: moved from New Members
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 10 users browsing this thread. (0 members and 10 guests)

Similar Threads

  1. Driver wiring advice needed...
    By Wal in forum General Electronics
    Replies: 17
    Last Post: 09-06-2014, 06:11 PM
  2. Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
    By craynerd in forum Motor Drivers & Controllers
    Replies: 1
    Last Post: 16-03-2014, 07:29 PM
  3. Stepper Driver / PSU / Breakout board Wiring ?
    By manofgresley in forum General Electronics
    Replies: 2
    Last Post: 16-08-2012, 05:41 PM
  4. Driver wiring to my computer for mach3 to control
    By AdCNC in forum Motor Drivers & Controllers
    Replies: 13
    Last Post: 01-04-2010, 12:27 AM
  5. wiring help
    By ste68blue in forum Stepper & Servo Motors
    Replies: 6
    Last Post: 29-07-2009, 10:23 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules