. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 19-09-2010 #2
    John S's Avatar
    Lives in Nottingham, England, United Kingdom.
    John S
    Last Activity: 23-09-2017 Has been a member for 9-10 years. Has a total post count of 2,073. Received thanks 141 times, giving thanks to others 45 times. Referred 1 members to the community.
    Take just the X axis as an example.
    The pulse + will go to pin 2, the direction + will go to pin3 and both pulse- and direction - will go to the ground terminal at the top of the board in the routout pdf file.

    Rest of the axis are different pins but all the minus go to the same ground(s)
    John S -
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to John S For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Driver wiring advice needed...
    By Wal in forum General Electronics
    Replies: 17
    Last Post: 09-06-2014, 06:11 PM
  2. Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
    By craynerd in forum Motor Drivers & Controllers
    Replies: 1
    Last Post: 16-03-2014, 07:29 PM
  3. Stepper Driver / PSU / Breakout board Wiring ?
    By manofgresley in forum General Electronics
    Replies: 2
    Last Post: 16-08-2012, 05:41 PM
  4. Driver wiring to my computer for mach3 to control
    By AdCNC in forum Motor Drivers & Controllers
    Replies: 13
    Last Post: 01-04-2010, 12:27 AM
  5. wiring help
    By ste68blue in forum Stepper & Servo Motors
    Replies: 6
    Last Post: 29-07-2009, 10:23 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules