Thread: looking, from Australia
-
27-09-2010 #1
New to cnc - no experience - not bad with a lathe and just looking to see if I want to go down this route.
Last edited by irving2008; 27-09-2010 at 01:04 PM.
-
27-09-2010 #2
Hi eltee and welcome to the site. Lots of info here to help you decide... most will tell you that once you have CNC'd you wont want to go back, it opens up so many possibilities...
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: Hi from QLD Australia
By Gus in forum New Member IntroductionsReplies: 2Last Post: 06-10-2011, 05:04 PM -
NEW MEMBER: Hi from Australia
By packmansdaddy in forum New Member IntroductionsReplies: 0Last Post: 05-06-2011, 10:36 PM -
NEW MEMBER: G'day from Australia
By packmansdaddy in forum New Member IntroductionsReplies: 1Last Post: 15-02-2011, 05:06 AM -
NEW MEMBER: Hi from Australia
By halfa in forum New Member IntroductionsReplies: 1Last Post: 17-12-2010, 03:43 PM -
NEW MEMBER: Hi from Australia
By amcc in forum New Member IntroductionsReplies: 1Last Post: 12-09-2010, 10:29 AM
Bookmarks