Boxford 190vmc upgrade

[swood1]

Hi all,

I have taken a photograph showing the board I have retained (mainly as it has the drives attached). With regards 0v, 12v, -12v, Ang, Dir, Ena. I believe these are all specific to the Spindle. My question is does anyone know if I can connect them directly to my BoB. I have worked out if Enable connector is 12v supply and when connected to the wire on the Lenze it starts the Spindle motor. I have also worked out that if you connect the 'dir' wire to 0v that also kicks the reversing relay.

Any help on how to wire to my BoB would be appreciated as struggling now. If you look in the photo XD, XC, ZD, ZC and CL5, CL6 are all the step, direction for the x, y, z axis which have all connected straight to my BoB.

PS. I have a PMDX-126 BoB and PMDX-107 Isolated Speed Control board although I am not 100% sure I need the 107 board.


Regards

Steven