Well here I am not knowing what to say. I'll start with the obvious and that is my knowledge of CNC, which is to say little or nothing. I have done a fair bit of reading and find the subject fascinating. I have only just found this site and the fact that it is based in the UK appeals to me after spending many happy hour on sites such as CNCzone and the Mach forums.

I am fairly well set up for conventional "knife and fork" machining. My workshop contains a couple of lathes - a Colchester Triumph and Student - Ajax and Shizuoka Universal Mills - An Elliot Surface Grinder - a Gates Cylindrical Grinder and of course all the other rubbish that goes along to support this tooling.

I have a good knowledge of electronics and electrics having served in the UK's Armed Forces, but have forgotten too much over the years.

Well Mod's will this be enough to allow me into the inner sanctum of mycncuk?

Mike