New member from Kent

**Dan** · 06-10-2010

Hello, my name is Danny.
I am a joiner, furniture maker living and working in Kent.
I have a joinery shop in Higham. Most of my work is one off bespoke stuff.
I want to build a CNC router. It needs to be able to cut 3m lenghtwise. Not
sure about the width though. I have a wall saw which handles 10 x 5 sheets.
I was thinking that as long as it was wide enough to cut Corian, 760mm and drill/groove
my tall carcass sides, a metre wide would suffice. Any thoughts...

Danny

**irving2008** · 07-10-2010

Hi Danny and welcome to the site. 3m long needs some careful design but I'm sure we'll be able to come up with some suggestions. I suggest you post your requirements/thoughts in the General Discussion forum to get a wider response....

**Peter Griffin** · 07-10-2010

Hello Dan and welcome to another Kent member :tup:

**pavlo** · 09-10-2010

Hi Dan

I thought I'd say hello, seeing as I am only a few miles away in Strood.

I have a small macine (600mm x 500mm) but I am a good way into the construction of a larger machine (2000mm x 1100) although not as long as the one you are planning. If you want to see my machine or discuss your plans in person, feel free to PM me.

**Dan** · 13-10-2010

Hi Pavlo, Thanks, I will take you up on the offer. I can use all the help I can get. Will PM you and post some of my ideas in Gen Diss as suggested by Irving

Originally Posted by pavlo

Hi Dan

I thought I'd say hello, seeing as I am only a few miles away in Strood.

I have a small macine (600mm x 500mm) but I am a good way into the construction of a larger machine (2000mm x 1100) although not as long as the one you are planning. If you want to see my machine or discuss your plans in person, feel free to PM me.