No rapid overide on Mach3

[John S]

That's what fresh air is for :rofl:

No seriously, I don't know of one, there is a Z inhibit button against the Estop where you can give it a value that Z can't exceed so if you say put 6mm into the box, press enter than then the inhibit button the tool will do all the X and Y moves but never drop lower than +6.00 m

[GeoffV]

John

One gets used to certain facilities and miss them when no longer available, I will have to change my techniques. Obviously when maching proffessionaly one rarely has time to just cut air but as I now have time perhaps I should just slow down a bit more.

Thanks GeoffV