Threaded View
-
29-08-2008 #1
Ok, yes, I know I'm going to get frustrated using stepper motors & rods out of 3 DEC dot matrix printers but hey...we've all got to start somewhere!
I live in North London...don't have the luxury of a shed, garage, spare room etc...so I've been consigned to an unconverted loft - basic to say the least - not even any boards down & I have to balance across the joists...ok., I jest (actually, it's not so bad at the moment but I'm sure it'll wear thin in November!).
Got my motors, my driver board, my PSU.... some steel rods (out of the printer!)...just got to figure out a way of 'gluing' them all together.
Anyway, it's good to find this place.....I felt alienated on forums where everyone can source "aluminium storefront watchacallit" (I've checked & whatever it is, it's not listed in the Argos catalogue).
Expect some naive line of questioning to commence imminently!
Cheers,
HankLast edited by HankMcSpank; 29-08-2008 at 08:35 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Vacuum pump for a large matrix bed cnc 5 by 10 foot
By gavztheouch in forum General ElectronicsReplies: 4Last Post: 03-11-2013, 06:01 PM -
Dust and Chip extraction for large matrix table machining centre.
By gavztheouch in forum Dust Extraction & CollectionReplies: 2Last Post: 29-05-2013, 10:03 PM
Bookmarks