Conect 121 Lathe - The toy collection grows!

[m_c]

It lives!
Or it did for a minute or so until the spindle fuse blew!
Used the OD taper wizard in Mach to test it on a bit steel, and the cut depth was obviously a little bit too much for the spindle to handle.

Put a new fuse in, reduced the cut depth, and it managed to finish this -
<pic removed>
So now I just need to get the wiring tidied up (mostly solder ground wires onto sheilding, and put a few more cable ties in), get a couple elbows to plumb in the coolant, drill a big hole for the spindle fuse holder, and it will of reached a useable state. I won't use the term finished, as I already have ideas for bits I still want to change/add, but they'll be done when time/funds permit.