Threaded View
-
15-11-2010 #1
Just been stripping all the old boards out my latest project, and figuring out where to put the new ones boards.
This is the original set-up-
31102010096 by mc_mtb, on Flickr
Now in that set-up, the motor controller is next to the main controller board, however given the level of technology involved, I doubt if noise/interference was an issue.
With the new set-up, I'll be using a Smoothstepper attached to a CNC4PC C23 BOB, which takes up most of the room from the bottom right corner along to the main capacitors, and a KBIC speed controller, and Gecko G251s.
Will mounting the KBIC controller next to the BOB or geckos cause any problems?
I'm currently planning on using the existing unsheilded wire for the steppers/240V wiring, and use sheilded wiring for any signal wiring.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
are these a newwer version usb break out board the ones from austrailia - better?
By nobby in forum General ElectronicsReplies: 0Last Post: 13-02-2014, 07:09 PM -
Break board 3-axis optical isolation, simple!
By thjremy in forum Electronic Project BuildingReplies: 0Last Post: 06-04-2013, 04:42 PM -
optoport v3 break out board wiring
By lez allen in forum Motor Drivers & ControllersReplies: 4Last Post: 26-02-2013, 07:38 PM -
Requirements on a break out board?
By Sodster68 in forum Motor Drivers & ControllersReplies: 3Last Post: 21-01-2013, 02:58 PM -
Controller Board Getting Very Hot / Allegro A3977
By MikeVA in forum Motor Drivers & ControllersReplies: 11Last Post: 08-09-2008, 03:04 AM
Bookmarks