Hi, friends!

CNC and robotics has fascinate me for all my life. My main ocupation is in electronics and automation, so cnc is not far away...
After long period of "sleep mode", last month I put back in operation my small mill (engraver), 400x300x70mm of travel, by using EMC Linux. EMC has gone long way till I used it last time (it was on RedHat distribution of Linux, not shure about release), and I was able to run the machine after few hours of playing with software. Great stuff, thank's to all EMC developers!
So, that's it, I think this forum will give me tons of ideas how to proceed.

Bye !

Sigi