Tapping Delrin for M10 threaded rod - doable?

[Lee Roberts]

I figured going up a notch in diameter might help on the straightness, but I'm still wavering on the extra work (friction) it'll cause my feeble steppers (taken from discarded dot matrix printers)

Just to put you in the picture...this will be my first CNC build. The plans are in my head...it'll be an evolution...it'll also be rather small (mainly because I have 6 free steel rods - with bushings- that are only 12" in length).

I think i would use some M6 if the machines going to be that small.

I'm aiming to do this as low cost as possible (as I'm sure to make mistakes), build 2 - if I ever get there - will be when I throw a bit more money at it. Looking at your blocks they seem a little small in comparison to the ones cheekymonkey linked to...I'd envisaged using blocks a little larger (just to spread the connectivity points wider into the table base).

I am CheekieMonkies, the blocks i posted there are 50x50, the blocks on the link to ebay are 50x20mm, the ones i posted as cheekiemonkies are the first ones i ever made, i ended up halfing the size on them because i didnt notice much diffrence it how much connectivity was going on.

Whether it matters one tot going stainless steel vs zinc plated steel.

Go with stainless steel !

3. Whether one delrin block or more is used per axis ...if so, is it better to use slightly larger blocks or not?

Using 2 nuts you find they resist each other.

I have also used "CockRam" befor, hes quite good.

Lee