MY 4`x 4` table

[Steve-m]

What you going to do just swap it for a button-head screw

Hi Lee

If you look at the second to last pic you will see I solved it by milling counterbores into the rack, I was going to put button heads in it but decided to counter bore instead

Steve

[Steve-m]

Hi All

decision made!! There is no going back now "Z" finished apart from a small second floating "Z" to get hight, I have drilled and tapped botom of "Dropper" plate to take a tool holder so I can use table as a router as well by sliding second "Z" up and bolting tool holder on.












Steve

[Steve-m]

Just a quick update, finished floating "Z" ready for THC, Luckily Jim Cullins from soundlogicus.com will still ship one to England along with a breakout board from Rob Cambell will make a good combination, I hope.