MY 4`x 4` table

[Steve-m]

What are you wanting Mach to do Steve?

Hi Kip

I`m trying to learn it, I seem to have some problems with my setup, but I don't know what I have done, this is my first play with cnc of any kind, ever so I'm a complete novice

1/ when I REF ALL HOME it hits the first switch ( all 3 are the same switch on each axis ) reverses off and ESTOPS!

2/ unless I change the % value in soft limits to 100% I can only get 20% speed

I have copied Bobs xml for the break out board, step by step manually into mach3 plasma. I think its in homing - limits my table is 1250mm square A & X are slaved, so soft max = 1250, soft min = 0, slow zone = 25, home off = 0.00 for X,Y,A and soft max = 0.00, soft min = -140, slow zone = 12, home off = 0.00 for Z

motor = 159.154 steps per, 10000 velocity, 1250 acceleration,

If you can help You will be My hero, I have fought with this for near a month, I have asked on most of the forums, and never got a reply,

Any body else any ideas??

Thank you in anticipation,

Steve