Thread: Timing Pulley Suppliers?
-
09-09-2008 #1
The last mechanical component I need to source for my z-axis is a 72tooth HTD 5mm pitch by 25mm wide, preferrably in alloy.
HPC do them at £££, RS only stock Gates (Gates use Cast Iron at that size), and I can't remember the name of the company usually recommended by the model engineering lot.
I also need a belt and a 24t for the motor, but they're easy enough to source.
Any suggestions?
-
01-11-2008 #2
bump...............
.Me
-
01-11-2008 #3
Have you tried Huco? They're cheap for racks, not tried them for puleys
http://www.huco.com/products.asp?p=true&cat=318
-
01-11-2008 #4
http://www.bearingboys.co.uk/72-5M-2...Pulley-21264-p
in steel I'm afraid but any use?Nothing is foolproof......to a sufficiently talented fool!
-
02-11-2008 #5
Oh, totally forgot about this.
I just went to HPC for the required pulleys. It's only for the one axis, and they had them in stock. For all the money I was likely to save, it didn't seem worth the hassle to try and get them else where.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Timing Pulley/Belt sizing software
By m_c in forum Computer SoftwareReplies: 4Last Post: 12-04-2014, 03:33 PM -
Making timing pulley - putting theory into action
By wiatroda in forum Metalwork Project ShowcaseReplies: 15Last Post: 28-11-2011, 02:22 AM -
Increasing timing pulley bore size from 3mm t0 3.175mm
By divdav in forum Gantry/Router Machines & BuildingReplies: 2Last Post: 14-05-2011, 09:45 AM -
4th Axis timing pulley + Axminster bandsaw review
By Jonathan in forum Metalwork Project ShowcaseReplies: 4Last Post: 09-04-2011, 07:31 PM -
help needed drilling bore hole in mxl timing pulley
By geekinesis in forum Gantry/Router Machines & BuildingReplies: 1Last Post: 02-02-2011, 01:07 PM
Bookmarks