. .
  1. #1
    m_c's Avatar
    Lives in East Lothian, United Kingdom. Last Activity: 2 Days Ago Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 2,908. Received thanks 360 times, giving thanks to others 8 times.
    The last mechanical component I need to source for my z-axis is a 72tooth HTD 5mm pitch by 25mm wide, preferrably in alloy.

    HPC do them at £££, RS only stock Gates (Gates use Cast Iron at that size), and I can't remember the name of the company usually recommended by the model engineering lot.

    I also need a belt and a 24t for the motor, but they're easy enough to source.

    Any suggestions?

  2. #2
    bump...............
    .Me

  3. #3
    Have you tried Huco? They're cheap for racks, not tried them for puleys

    http://www.huco.com/products.asp?p=true&cat=318

  4. #4
    Nothing is foolproof......to a sufficiently talented fool!

  5. #5
    m_c's Avatar
    Lives in East Lothian, United Kingdom. Last Activity: 2 Days Ago Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 2,908. Received thanks 360 times, giving thanks to others 8 times.
    Oh, totally forgot about this.
    I just went to HPC for the required pulleys. It's only for the one axis, and they had them in stock. For all the money I was likely to save, it didn't seem worth the hassle to try and get them else where.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Timing Pulley/Belt sizing software
    By m_c in forum Computer Software
    Replies: 4
    Last Post: 12-04-2014, 03:33 PM
  2. Making timing pulley - putting theory into action
    By wiatroda in forum Metalwork Project Showcase
    Replies: 15
    Last Post: 28-11-2011, 02:22 AM
  3. Increasing timing pulley bore size from 3mm t0 3.175mm
    By divdav in forum Gantry/Router Machines & Building
    Replies: 2
    Last Post: 14-05-2011, 09:45 AM
  4. 4th Axis timing pulley + Axminster bandsaw review
    By Jonathan in forum Metalwork Project Showcase
    Replies: 4
    Last Post: 09-04-2011, 07:31 PM
  5. help needed drilling bore hole in mxl timing pulley
    By geekinesis in forum Gantry/Router Machines & Building
    Replies: 1
    Last Post: 02-02-2011, 01:07 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •